I'm new to owning an lo206, I've been getting help along the way as I tinker with the kart and all its components. This morning I was working on adjusting the idle speed as it was idling high at around 3k rpm, I first started by turning the mix all the way to the right to lean it out, followed by a quarter turn to the left, I watched as the rpm dropped all the way to 1800, and from there I was having trouble keeping it idling without holding the throttle slightly. I Tried to turn the mixture screw to the left as instructed, but the rpm never went back up.
After about 6 hours of r&d to try and diagnose the problem here's a list of things I changed so far: New pulse line, fuel is flowing into the carb no problem. Spark plug is giving a spark. I took the float bowl off and there was fuel inside, emptied it and fuel is going into it. Is there anything else I could be missing that would cause my engine to not start?
edit: I have not adjusted the float height either. I pulled the pilot screw and checked to make sure it wasn't pugged up but it was clean.
After about 6 hours of r&d to try and diagnose the problem here's a list of things I changed so far: New pulse line, fuel is flowing into the carb no problem. Spark plug is giving a spark. I took the float bowl off and there was fuel inside, emptied it and fuel is going into it. Is there anything else I could be missing that would cause my engine to not start?
edit: I have not adjusted the float height either. I pulled the pilot screw and checked to make sure it wasn't pugged up but it was clean.