https://www.ebay.com/itm/274010930444
Can't seem to find the correct engine.
Here is a cam with the lobes reversed.
Can't seem to find the correct engine.
Here is a cam with the lobes reversed.
Duke do you go stright too the axle on the right or using a jackshaft there also . Nice setup .Here's what I did...
Question - did you cut the shaft and rotate the lobe too the needed position ?
Reversed flathead. Reversed animal on Hamilton Brothers Karting youtube.
No, you have to grind one from scratch. Stop and think, lobes are running backwards, ramp on wrong side and lobe spread is all wrong. I did on first experimental run drill 1/4 hole thru center of cam, cut lobes off turned them around and indexed them to run backwards, tacked it together and mocked it up in block. Then gave information to cam company to grind one. Lot of other issues to work through. Rod is trying to come through lobes at wrong time. Lobes hit crank. Arc rod dippers angled. When you reverse it hits case and that's just a few of issues.Question - did you cut the shaft and rotate the lobe too the needed position ?